impinj RShell - Page 37

RShell Reference Manual
36. Proprietary and Confidential Revision 4.2, Copyright © 2009, Impinj, Inc.
Table 4-40 Show Network mDNS Response Parameters
Table 4-41 Show Network NTP Response Parameters
Table 4-42 Show Network Summary Response Parameters
Argument Format Description
PrimaryInterface string The primary network device enabled at start
up e.g. ‘eth0’.
ActiveInterface string The currently active network device e.g.
‘eth0’.
Hostname string The current hostname of the reader.
Table 4-43 Show Network IP Summary Response Parameters
Argument Format Description
connectionStatus (Init |
Connected |
Disconnected)
Current state of the ethernet interface.
Argument Format Description
mDNSStatus (enabled | disabled) Indicates the current state of the mDNS service.
Argument Format Description
NtpServerDynamic<n>Address
NtpServerStatic<n>Address
string | IP Address Hostname or IP address of the Nth static or
dynamic NTP server
NtpServerDynamic<n>State
NtpServerStatic<n>State
( Synchronized |
Polled |
SymmetricActive |
SymmetricPassive |
ReceivingBroadcast |
SendingBroadcast )
The current state of the first dynamic NTP
server. (When the reader is trying to use a
server, it will remain in the state, “Polled,” until
it has successfully communicated with the
server eight times. During this process, the
“NtpServerDynamic/Static<n>Reach
parameter will generally transition through 1,
3, 7, 17, 37, 77, 177, and 377.
When the reader has selected a server and
locked on, the state parameter will become
“Synchronized.”
NtpServerDynamic<n>Stratum
NtpServerStatic<n>Stratum
integer The current stratum number of the NTP server
NtpServerDynamic<n>Reach
NtpServerStatic<n>Reach
integer The reachability register of the NTP server