Impulse IT8012 - Press Cable 1

14
Step9 Route The Weight Cable
1)Put the clip tied on the weight pin leash onto the Top
Plate(#41) as shown,next the Connect the Weight Ca-
ble(#24) to the Top Plate(#41).
2)Route the Weight Cable(#24) up and over the two Pul-
leies A(#31) ,and secure them to the Main Upright(#1)
using:
3)Route the Weight Cable(#24) down and under the Pul-
ley B (#31),and secure them to the Main Upright(#1)
using:
4)Route the Weight Cable(#24) around the Pulley C(#31)
as shown, then secure them to the Side Upright(#2)
using:
5)Route the Weight Cable(#24) under the Pulley D(#31),
then secure them to the Side Upright(#2) using:
6)Route the Weight Cable(#24) up and over the Pulley
(#31) then secure them to the Pulley Block(#22) using
7)Route the Weight Cable(#24) down and connect the
looped end to the Side Upright(#2) using
8)Slect an approprate weight using the weight pin.
9)Adjust the tension of the Weight Cable(#24) and the
press cable(#23) using the Jam Nut.
10)Make sure that the cables are in grooves of all pul
leies then fully tighten all bolts and nuts.
two Allen Bolts(#67) M10×45
two Nylon Locknuts(#78) M10
four Washers(#76)
one Shoulder Bolt(#70) M10×50
two 4.5” Pulley Covers(#92)
two Nylon Locknuts(#78) M10
one Shoulder Bolt(#70) M10×50
one Washer(#76)
one 4.5” Pulley Cover(#92)
one Nylon Locknut(#78) M10
one Shoulder Bolt(#70) M10×50
one Nylon Locknut(#78) M10
two 4.5” Pulley Cover(#92)
one Shoulder Bolt(#70) M10×50
one Nylon Locknut(#78) M10
two 4.5” Pulley Covers(#92)
one Allen Bolt(#96) M10×40
two Washers(#76)
one Nylon Locknut(#78) M10
ΦΦ
ΦΦ
ΦΦ
11× 20×2
11× 20×2
11× 20×2
E
:
:
-