2.0 Page 2.0 - 2 TS-LLD INSTALLATION GUIDE
Materials Required
(continued... )
❒
(1) ring lug for the 14 AWG earth ground connection at the pump relay box
❒
(1) short 1/2 inch nipple — 2-1/2 to 3 inches long, or 1/2 inch 90 degree, and
hardware fittings to mount the CU to the relay box. (Or you may wall-mount the
control unit with appropriate fasteners, and use 1/2 inch EMT and fittings.)
❒
*
Steel stem Replacement Check Valve Kit (RedJacket P/N 144-184-5) to
replace older all plastic check valves – for older RedJacket pumps only
❒
*
Approved Pump Relay (Motor Control) Box – to comply with codes, retrofit
system to add a motor control box inside of the station
*
= Occasionally Required
❒
this Installation Manual – INCON P/N 000-1359 most current revision
❒
(1) Completed Warranty Registration Card –
(supplied with each TS-LLD)
❒
TS-LLD Quick Reference guide – INCON P/N 000-1447
(supplied with each
TS-LLD).
Leave all TS-LLD Quick Reference guide(s) on-site for use by the
station owner, shift managers / personnel
!
❒
Also, for use by the station owner, shift managers / personnel, provide the
name(s), phone number(s) of the local inspection agency and other applicable
information, instructions and regulations should a line leak be detected.
❒
Regulations and documentation: Applicable Local and State Codes, the
Manufacturers’ manuals and wiring diagrams of the — Dispenser, Submersible
Pump, and Relay Box (including other equipment not listed here and the sites’
electrical power distribution).
Tools Required
❒
Digital multimeter and test leads (high quality professional instrument)
❒
One each: wire strippers, cutters, and crimp splice tool
❒
Various sizes of flat and phillips bladed screwdrivers
❒
One 12 inch long adjustable wrench
❒
One 2 inch open end hex wrench
❒
Two 7/8 inch open end hex wrenches
❒
One socket set, extension, and square socket for a 1/4 inch NPT square headed
hole plug
—
❖
—
To Next Page
Loading...