Incon TS-LLD - Note

2.2 Page 2.2 - 12 TS-LLD INSTALLATION GUIDE
Figure 2.2-13 Typical Installation INCON TS-LLD Line Leak Detector
INCON TS-LLD Line Leak Detector
Typical Installation in Leak Detector Port
TS-LLD LSU # 1
(Leak Sensing Unit # 1)
at submersible
pump housin
g
Tank - Pump # 1
Electrical
Power Panel
Pump
Relay
Boxes
NOTE:
A TS-TGI Tank Gauge Interface
module is required to connect
the TS-LLD Line Leak Detector
system to an INCON TS-1000
Tank Sentinel console.
See the TS-TGI Install Manual.
Existing
Conduit
(Pump 2)
Existing
Conduit
(Pump 1)
Submerged
Turbine
Pump
1
2
TS-LLD CUs
(Control Units):
# 2 and # 1
TS-LLD LSU # 2
(Leak Sensing Unit # 2)
at submersible
pump housin
g
Tank - Pump # 2
Epoxy
Filled
EYS
Seal
Fitting
Dispenser
# A
Explosion-
proof
Junction
Box
Dispenser
# X
NOTE:
A TS-TGI Tank Gauge Interface
module is required to connect the
TS-LLD Line Leak Detector system
to an INCON TS-1000 Tank Senti-
nel console. See the TS-TGI Install
Manual.
For TS-1001/2001 Tank Sentinel
consoles, use the LLD /
I interface
...see the OPTIONAL TS-LLD TANK
SENTINEL ATG CONSOLE
INTERFACE chapter in this manual.
Reference Schematic Figure 2.3 - 8