PPU-S User’s Manual
Page 15 of 20 Copyright 2023 IndeeLift, Inc. All Rights Reserved 08/2023
Once a lift is complete, using the wired remote, position the PPU-S seat to the floor or a normal seated height
based on the preference of the primary user and return the PPU-S to its storage location.
Standing Function
While the primary function of the PPU-S is lifting people from a seated position, the need to lift a standing person
a few inches occur regularly for many people. Reaching the tall cabinets in the kitchen or getting up on a tall bed
are all activities that are not possible for many people with mobility challenges. In assisted living or skilled nursing
environments, a few inches of lift can get a patient onto an exam or x-ray table. The PPU-S provides a safe and
reliable method to rise those few inches to reach that space that was out of reach without the PPU-S.
This function is accomplished by moving the rise-assist handles from the lower mounting brackets to the
upper mounting brackets and securing the seat plate in the locked position. The PPU-S is then placed
alongside the cabinet, shelf, closet, or other hard to reach location. With the seat in the fully lowered position,
the user stands on the seat and grasps the rise-assist handles. The user, or a helper, then presses the up button
on the wired remote to raise the seat to the required height but no higher than 14” from the floor as depicted on
by the top of the red line located on the caution label. (see Figure E, below).
Once the lift is complete, using the wired remote, position the PPU-S seat to the floor or a normal seated height
based on the preference of the primary user and return the PPU-S to its storage location.
Figure E: Floor to Stand – Standing Function
ALWAYS PLACE THE MOUNTING RAMP SEAT LOCKS IN THE “LOCKED”
POSITION WHEN USING THIS LIFT IN A STANDING FUNCTION AID TO AVOID MISHAPS THAT COULD
RESULT IN DEATH OR SERIOUS INJURY.
WARNING
Figure E – Seated Transfer to the PPU-S
To Next Page
Loading...