IndeeLift PPU-S - Battery Charging and Moving the PPU-S; Charging the Battery Process

To Next Page

To Previous Page

PPU-S User’s Manual

Charging the Battery:

It is recommended that the PPU-S be fully charged before its first use.

Position the PPU-S near a standard commercial AC wall power outlet.

Attach the female end of the AC power cord to the connector on top of the PPU-S’s battery charger. Fig 2

Attach the male end of the AC power cord to a standard commercial AC wall power outlet. Fig 3

The LED light on the battery charger will illuminate green within 15 seconds. Fig 2

The LED light on the battery will illuminate red when the battery is low and will change to green upon reaching a

full charge. Fig 4 and 5

After an initial charge of up to eight hours, the battery is fully charged and the red LED on the battery turns green.

Fig 4 and 5

Once the unit is fully charged, disconnect the power cord from the wall outlet and wrap it around the cord bracket

on the charger like you would a vacuum cleaner. Fig 6

Fig 1 Fig 2 Fig 3 Fig 4 Fig 5 Fig 6

When the PPU-S’s battery is running low, it will emit a steady tone when pressing

the up or down button on the wired remote. This indicates that it’s time to recharge the battery. Each

charge is good for at least 10 lifts depending on the weight of the person being lifted. If you need to use

the PPU-S when the battery requires charging, or if the battery fails to operate the PPU-S, the lift can be

operated with the power cord connected to an AC wall outlet. Fig 3

California requires the following notice: WARNING: Lithium-ion batteries and

products that contain lithium-ion batteries can expose you to chemicals including cobalt lithium nickel

oxide, and nickel, which are known to the State of California to cause cancer and birth defects or other

reproductive harm.

Moving the PPU-S

Almost any able-bodied person, as young as 8 years old and under adult supervision, can move the PPU-S

around in a single level space. The person moving the PPU-S stands behind the lift and places one foot on the

motor at the rear of the unit and then gently tilts the PPU-S rearward by pulling the handles toward them. They

can now pull or push the PPU-S to the required location.

NOTICE

WARNING