IndeeLift PPU-S - Rise-Assist Handles

To Next Page

To Previous Page

PPU-S User’s Manual

Rise-Assist Handles

The rise-assist handles provide support and balance when standing from the seat or when using the PPU-S in a

standing mode. The rise-assist handles are positioned on the lower bracket for seated operation and on the

upper brackets for standing operation. If desired, one or both rise-assist handles can be swung away from the

seat by lifting one inch and then rotating them away from the seat. They are also removable to allow a direct

transfer to a wheelchair or other destination. To remove a rise-assist handle, lift the handle upward.

To insert a rise-assist handle, push the lower end through the receiver bracket until the lower end bottoms out

on the domed base (Fig 2), then push firmly until it is seated and the lock-pin located on the rise-assist handle is

resting securely in the bracket.

Fig 2

Fig 1

Rise-Assist Handles Shown in Lower and Upper Brackets