Inepro 4PU Series - Pulse Type Configuration; SO Pulse Width Configuration; Modbus ID Configuration; Modbus Baud Rate Configuration

18 - Inepro Metering - 4PU & 4PS
7.6.4 Pulse type setting
The default pulse type setting is active & reactive. This means that the two pulse outputs pulse based on the active
and reactive energy. The pulse type can be set to forward & reverse, which means that the pulse outputs pulse based
on forward and reverse active energy.
7.6.5 S0 Pulse width
The default S0 pulse width is 30ms. The pulse width setting can be modied to 2-99ms (depending on the imp/kWh
setting).
7.6.6 Modbus ID
The Modbus ID can be set from 1 to 247, the default Modbus ID is 1.
7.6.7 Modbus baud rate
The default Modbus baud rate setting is 9600. The Modbus baud rate setting can be modied to 115.200 / 56.700 /
38.400 / 19.200 / 4800 / 2400 / 1200 / 600 / 300 bps.