25
Set Up
Booster Car Seat
Converting to a child booster
Figure 1
Figure 2
Figure 3
Disengage the buckle, undo the cover ap located
between the leg straps, remove buckle pad and
place the buckle in the recessed section of the
plastic base. Close the ap in the cover (refer to
Figure 1 & 2).
Disengage shoulder straps from “G” connecting
plate as shown on page 12 (refer to section
“Shoulder Slot Height” - Step 1 & 2). Remove and
store Shoulder Pads & Buckle Pad. Lift the front ap
of the seat cover (see Figure 3).
UNDER COVER
Thread the harness strap back through the top
shoulder slots and reconnect the ”G” plate as per
page 12 (refer to section “Shoulder Slot Height” -
Step 3 & 4). Tightening the harness with harness
adjuster strap located at the front of the seat.
Place the two buckle tongues in the recess in the
plastic base at point (A) in Figure 4. Resecure front
ap of seat cover.
FOR USE OF THIS RESTRAINT AS A BOOSTER
SEAT THE HARNESS MUST BE STORED BEHIND
THE COVER. FOLLOWING STEPS EXPLAIN HOW
THIS IS TO BE DONE.
Step 1:
Step 1:
Step 2:
Step 3:
Determine whether your child requires the additional padding provided with this restraint, to
ensure a safe and snug t in the restraint. Refer to page 6 for suggested padding combinations.
Selection of appropriate padding combinations
IMPORTANT
!
(A)
Figure 4
The restraint is now ready as a booster seat
To Next Page
Loading...
