30
SAFE GRIP BELT CLAMP
It is important that the lap belt must be firmly across
the thighs. The Safe Grip locks the lap belt to
ensure a rm t across the thighs, and avoids slack in
the lap belt. This t ensures that the lap belt does not
ride up into the soft abdominal region of the child,
which may cause internal injury.
To install the Safe Grip (red belt clamp);
Continue from Step 6: while holding the belts tight
open the Safe Grip and clamp the “sash section” of
the vehicle seat belt by closing the barrel section of
the red belt clamp in the direction of arrow 3 (refer
Figure 5) and then locking with the toggle section
by pushing in the direction of arrow 4 (refer Figure
5) Note: Positioned as close as possible to the
buckle and tongue. When the Safe Grip (red belt
clamp) is secured in place, the lap section is now
tightly holding your child in place, independent of
the sash section.
The Safe Grip (red belt clamp) can be left located
on the sash belt when the child is removed from the
booster. It is then ready for the next use. Reposi-
tioning of the Safe Grip (red belt clamp) may be
required as the child grows. The Safe Grip (red belt
clamp) must be removed when the child restraint is
not installed to allow other users to use the seat
belt as a lap/sash seat belt. Always keep the Safe
Grip (red belt clamp) in pocket provided when not in use.
Use
Using lap-sash seat belt
Safe Grip (if supplied)
Booster Car Seat
LAP SECTION
SAFE GRIP (B)
(red belt clamp)
SASH SECTION
BUCKLE (A)
(AND TONGUE)
3
BARREL
SECTION
4
TOGGLE
SECTION
ATTACH TO
SASH SECTION
ONLY
Figure 5
Figure 4
Pull the lap belt tight by rst pulling on the lap belt in
the direction of arrow 1 (refer Figure 4). Pull the sash
belt tight in the direction of arrow 2.
REMOVE ALL
SLACK FROM
SEATBELT
WARNING
!
• ALWAYS USE THE SASH GUIDE
SASH
GUIDE
*Can be purchased separately visit
http://store.infasecure.com.au/
To Next Page
Loading...
