Pull to
Lengthen
Pull to Tighten
Figure 9Figure 8
Figure 9Figure 7
After correctly installing the restraint in your
car, roll up and place any excess strap in the
storage pocket provided (refer Figure 9).
Tether Storage
Figure 9
Storage
Pocket
Step 5:
Step 6:
Step 7:
Note: If no upper anchorage tting is available refer to
Pages 49 & 50.
Hook the attachment clip to the anchor tting. Ensure
there are no twists in the top tether strap (refer to
Figure 7).
Pull to tighten to remove all the slack, from the upper
anchorage strap. Do not overtighten as this could
cause the restraint to lift off the vehicle seat (refer to
Figure 8).
Store any excess webbing, from the top tether strap,
in the storage pocket provided on the restraint (refer
to Figure 9).
FOLLOWING THE INSTALLATION OF
THE CHILD RESTRAINT A SMALL
AMOUNT OF MOVEMENT IS DEEMED
ACCEPTABLE.
NOTE
CAUTION: CHILDREN CAN BE
INJURED OR RESTRAINTS AND
TOP TETHER STRAP DAMAGED
BY UNSECURED CARGO IN A
COLLISION. SECURE OR
REMOVE HAZARDOUS CARGO
BEFORE USING THIS CHILD
RESTRAINT.
Always secure the loose end of the
top tether strap to prevent it
hanging out of the car or being
accessible by the child.
To Next Page
Loading...
