5
English
6. Replacing and installing the sensor
a. Press the eject button to release the battery cover.
b. Grasp the sensor release tab and gently pull the sensor out.
c. Align the new sensor with the rails.
d. Gently push the sensor along the rails until it clicks into place.
NOTE: Do not force the sensor. If it does not slide freely, check
alignment and try again.
e. Reinstall the battery cover.
7. Replacing filters
a. Unscrew the probe tip and remove the filter.
b. Insert the new filter into the probe tip.
c. Screw on the probe tip.
8. Charging and Battery Information
To charge D-TEK Stratus, plug the supplied wall or car charger into
an appropriate power source and plug the micro USB cable into the
D-TEK Stratus micro USB power input. The on-screen battery sym-
bol shows the charge percentage and indicates that the battery is
charging.
NOTE: D-TEK Stratus can be operated while charging.
NOTE: A new lithium ion battery will have a charge of 30% or
less. It is recommended to fully charge the battery
before use. Allow approximately three hours for a full
charge.
Eject button
Sensor release tab
To Next Page
Loading...
Need help?
General
