Need help?Do you have a question about the Inficon Gemini MAG500 and is the answer not in the manual?
General| Accuracy | ±15% of reading |
|---|---|
| Power Supply | +24 V DC |
| Operating Voltage | 24 VDC |
| Output Signal | 0…10 V DC, Logarithmic |
| Sensor Type | Pirani / Magnetron |
Explains safety symbols and their meanings in the manual.
Details the required qualifications for personnel performing tasks.
Provides essential safety guidelines for operating and handling the equipment.
Outlines INFICON's liability and warranty conditions for the product.
Details the relationship between the measured signal and pressure.
Explains how different gas types affect MAG5xx pressure readings.
Explains how different gas types affect MPG5xx pressure readings.
Provides physical dimensions and connection details for the gauges.
Instructions for connecting the gauge to a vacuum system.
Guidance on connecting the gauge to a power source.
Details for connecting using the FCC 68, 8-pin connector.
Details for connecting using the D-sub, 9-pin connector.
Explains the status indicators for MAG50x models.
Explains the status indicators for MPG50x models.
Steps for starting up the MAG5xx gauge.
Steps for starting up the MPG5xx gauge.
General information on gas type dependency for measurements.
Describes the delay before the cold cathode ignites.
Information on contamination effects and prevention.
Procedures for adjusting and calibrating the gauge.
Steps for cleaning and replacing components.
Checks for faults within the measuring chamber.
Guide for replacing specific parts.
Guide for replacing the complete measuring chamber.
General troubleshooting guidance for errors.
To Next Page