What to do if the Inficon Measuring Instruments output signal is permanently 0V?
If the output signal is permanently 0V, there might be several reasons. First, check the sensor cable for defects or incorrect connections. Second, ensure that the power supply is turned on. Third, if there is an error, remedy it. Finally, the gauge might be in an undefined state; in this case, turn the gauge off and on again after 5 seconds to reset it.
What to do if Inficon PSG550 Measuring Instruments shows FAIL EEPROM?
If the device displays 'FAIL EEPROM', it indicates an EEPROM error. You can try turning the gauge off and on again after 5 seconds to reset it. If the issue persists, consider replacing the gauge.
Why Inficon PSG550 shows FAIL SENSOR?
If the device displays 'FAIL SENSOR', it could be due to the electronics unit not being compatible with the sensor, in which case you should replace the sensor. If that's not the issue, consider replacing the entire gauge.
What to do if Inficon PSG550 Measuring Instruments shows FAIL PIR1?
If the device displays 'FAIL PIR1', it could be due to a defective Pirani sensor, consider replacing the sensor. Also, check the connections between the electronics unit and the sensor to ensure they are correctly mounted.
Calibrate the gauge for accurate pressure readings under constant conditions.
Guide for replacing the sensor if it's contaminated or malfunctioning.
Diagnose and resolve common problems encountered with the gauge.
List of harmonized and international standards the gauge complies with.
Details of the manufacturer and signatory personnel.
General| Technology | Pirani |
|---|---|
| Accuracy | ±15% of reading |
| Number of Sensors | 1 |
| Output Signal | 0…10 V DC, linear |
| Materials exposed to vacuum | Stainless steel |
To Next Page