EasyManua.ls Logo

INFILED Wallpaper Series - Safety Information; Protection from Electric Shock

INFILED Wallpaper Series
35 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2
Safety Information
WARNING!
Read the safety precautions in this section before installing,
powering, operating or servicing this product.
Read this manual before installing, powering or servicing this product. Follow the safety precautions
listed below and observe all warnings in this manual and pay attention to the warnings printed on the
product.
If you have questions about how to operate the panel safely, please contact your INFiLED supplier.
The following symbols are used to identify important safety information on the product and in this
manual.
PROTECTION FROM ELECTRIC SHOCK
The product must be powered with AC power within the range of 100 – 240 V
nominal at 50/ 60 Hz only.
Disconnect the entire installation from power before carrying put installation or
maintenance work. Make sure the power cannot be reconnected, even by
accident.
Double-pole/neutral fusing is used. If the installation is not completely
disconnected from power, parts may remain live even if one of the two mains
fuses has blown.
When not in use, the product should be disconnected.
Always ground (earth) the product electrically.
Use only a source of power that complies with local building and electrical codes
and has both overload and ground (earth) -fault protection.
Connect the Header to power using only the cables supplied by INFiLED for this
product.
Protect power cables from water and rain.
Connect the Header to power using only 32 amp-rated industrial Type B power
plugs and socket outlets that comply with IEC 60309 (or a comparable national
standard) and provide an electrical connection to ground (protective earth).
External power switches or socket outlets used to supply Headers with power must
be located near the product and easily accessible so that the product can easily be
disconnected from power.
Do not connect any other device than Wallpaper series panels to the power
throughput connector in the base of the product.
Connect no more than seventeen Wallpaper panels in total to one main power
cable
Before using the product, check that all power distribution equipment and cables
are in perfect condition and rated for the current requirements of all connected
devices.
Do not use the product if the power cable or a power plug is in any way damaged,
defect or showing signs of overheating.
Do not attempt to open any cover.
Refer any service operation not described in this manual to a qualified technician.
2019
INFiLED Wallpaper User’s manual