IMC301/302A MCU Getting Started Guide
About this document
Scope and purpose
The IMC300A motor controller series, namely IMC301A and IMC302A product line, contains two distinct cores,
the Motion Control Engine (MCE) for control of a motor and/or power factor correction (PFC) and an additional
microcontroller (MCU) based on an Arm® Cortex® -M0 processor.
This application note is a getting started guide to quickly get up and running with the IMC300A MCU. Detailed
information on the functionality and configuration of the MCE, is beyond the scope of this document and can
be found in the iMOTION™Motion Control Engine Software Reference Manual. For example code and
explanation of example code please refer to document [3].
Intended audience
This document is intended for customers who would like to get started with the IMC300A MCU core.
Table of contents
About this document ....................................................................................................................... 1
Table of contents ............................................................................................................................ 1
1 Brief Overview of MCU ............................................................................................................ 2
2 Getting Started ...................................................................................................................... 3
2.1 Requirements .......................................................................................................................................... 3
2.1.1 Hardware Requirements .................................................................................................................... 3
2.1.2 Software Requirements ..................................................................................................................... 3
2.1.2.1 Arm Keil MDK ................................................................................................................................. 3
2.1.2.2 µVision® IDE ................................................................................................................................... 3
2.1.2.3 Infineon IMC300A DFP ................................................................................................................... 3
2.2 Installing IMC300A DFP onto Keil µVision® IDE ....................................................................................... 4
2.3 Setting up J-LINK/J-TRACE Cortex as debugger .................................................................................... 5
2.4 Building A Project and Downloading to Flash Memory ......................................................................... 9
3 Troubleshooting FAQ ............................................................................................................. 12
4 Reference ............................................................................................................................. 13
Revision history............................................................................................................................. 14
To Next Page
Need help?
General
