Infineon XMC4700 - Page 18

18 of 31
2019-12-02
Using Infineon’s radar baseboard XMC4700 and BGT24LTR11 radar
shield with Arduino
Set-up guide
Software set-up
Figure 17 Example sketch: Radar_Pulsed_Doppler_LED
2. Navigate to Tools > Board > XMC4700 Radar Baseboard (as shown previously in Figure 10) to select the radar
baseboard as the target kit.
3. Compile the sketch by clicking the “Verify” button (Figure 18). A success message will be displayed on
compilation completion (Figure 19).
Figure 18 Compiling the sketch
Figure 19 Compilation successful