3. PRINTER FUNCTIONS
KPM210/216
183-
for the 300 dpi model :
medoM
noitceridlacitreVnoitceridlatnoziroH
stod.NIPDIPD)k(ataDfo.N
0
elgnistod8
ytisned
8001051652xHn+Ln
1
elbuodtod8
ytisned
8001003652xHn+Ln
23
elgnistod42
ytisned
420030513x)652xHn+Ln(
33
elbuodtod42
ytisned
420030033x)652xHn+Ln(
[Notes] • The nL and nH commands indicate the number of dots of
the bit image in the horizontal direction. The number of dots
is calculated using: nL + nH × 256.
• If the bit image data input exceeds the number of dots to be
printed on a line, the excess data is ignored.
• d indicates the bit image data. Set a corresponding bit to 1
to print a dot, or to 0 to not print the dot.
• If the value of m is outside the specified range, nL and data
following it are processed as normal data.
• If the width of the printing area set by GS L and GS W is
less than the width required by the data set using ESC * , the
excess data are ignored.
• To print the bit image use LF, CR, ESC J or ESC d.
• After printing a bit image, the printer returns to normal data
processing mode.
• This command is not affected by the emphasized, double-
strike, underline (etc.) print modes, except for the upside-
down mode.
• The relationship between the image data and the dots to be
printed is as follows:
(Tab.A.3)
www.ipcprint.com
To Next Page
Loading...