3. PRINTER FUNCTIONS
KPM210/216
603-
[Notes] • The lenght of residual paper reported is just as an indication
because tolerances and other factors are not taken into con-
sideration (paper thickness, roll core diameter, roll core thick-
ness). The virtual paper-end limit is set by the command GS
µ.
• To set virtual paper-end limit, measure the length of the
paper from near paper end to the end of the roll, using sev-
eral of them.
[Default]
[Reference]
[Example]
SGSG
SG
SGSG ΓΓ
Γ
ΓΓ
[Name] Reading number of cuts performed from the printer
[Format] ASCII GS Γ
Hex 1D E2
Decimal 29 226
[Description] Reading the number of cuts performed from the printer.
The command return a string that points out how many cuts
are performed by the printer, for example if there are per-
formed 2376 cuts, it will be:
‘2376 cuts’
[Notes]
[Default]
[Reference]
[Example]
SGSG
SG
SGSG ΠΠ
Π
ΠΠ
[Name] Reading of length (cm) of printed paper
[Format] ASCII GS Π
Hex 1D E3
Decimal 29 227
[Description] Reading of length (cm) of printed paper.
The command return a string pointing out how much paper is
printed, for example if the printer has print about 2515,5 m, it
will be:
(Tab.A.3)
www.ipcprint.com
To Next Page
Loading...