inniton.es10
English
Carbon lter - not supplied
Activated carbon lter can be used to trap odors. Normally the activated carbon lter should be
changed eyery 3 to 6 months according to your cooking habits. The installation procedure of activated
carbon lter is as below:
1. Before installing or replacing the carbon lters, disconnect the
mains power to the unit.
2. Press the lter lock and remove the mesh lter.
3. Turn the carbon lter on both sides of the motor anti-clockwise.
Replace thecarbon lters with the new carbon lters.
4. Place the mesh lter.
5. Connect the power supply to the wall socket.
Note: Make sure the lter is securely locked. Otherwise, it would loosen and cause danger.
When activated carbon lter attached, the suction power will be lowered.
Bulb replacement
Note: Before changing the lights, make sure that the appliance isturned off and unplugged.
Protect against danger when changing lights, such as wearing gloves.
To change the cooker hood lights, follow the steps below:
Remove the grease lter.
Use a tool or the hand to press the spring splinter of both sides of LED light to the inside, until the light is
pressed out.Then slightly pull the light connecting wire out and replace the lights.
Apply the reverse procedure to install the light back.
ILCOS D code for this lamp is: DSR-1.5/30-S-64
– LED modules– round lamp
– Max wattage: 2×1.5 W
– Voltage range: DC 12V
– Dimensions:
Maintenance and cleaning
IMPORTANT!
The bulb must be replaced by the manufacturer, its service agent or
similarly qualied persons.
Always switch off the electricity supply before carrying out any operations
on the appliance. When handling bulb, make sure it has completely cooled
down before any direct contact with hands.
When handling bulbs hold with a cloth or gloves toensure perspiration does
not come in contact with the bulb as this can reduce the life of the bulb.
To Next Page
Loading...