What to do if the lights are not working on my Infiniton CMPG-702 Ventilation Hood?
If the lights on your Infiniton Ventilation Hood aren't working, the most likely cause is broken or faulty globes. Replace the globes following the instructions provided.
What to do if my Infiniton CMPG-702 light is on, but the motor doesn't work?
If the light is on but the motor of your Infiniton Ventilation Hood isn't working, it could be due to several reasons. First, check if the fan switch is turned off and select a fan switch position. If the issue persists, it may be due to a fan switch or motor failure.
Why is my Infiniton CMPG-702 leaking oil?
Oil leakage from your Infiniton Ventilation Hood can occur if the one-way valve and the outlet aren't tightly sealed. Remove the one-way valve and seal it with sealant. Alternatively, leakage might be from the connection of the chimney and cover, in which case you should take the chimney down and seal it.
What to do if my Infiniton Ventilation Hood light and motor do not work?
If neither the light nor the motor of your Infiniton Ventilation Hood are working, check your house fuses and reset or replace them if they are blown. Also, ensure the power cord is properly fitted to the power outlet and that the outlet is switched on.
How to fix insufficient suction on my Infiniton CMPG-702 Ventilation Hood?
Insufficient suction in your Infiniton Ventilation Hood may be due to the distance between the hood and the gas top being too far. Refit the cooker hood to the correct distance.
How to fix an inclining Infiniton Ventilation Hood?
If your Infiniton Ventilation Hood is inclining, it's likely that the fixing screw isn't tight enough. Tighten the hanging screw to make the hood horizontal.
General| Type | Wall-mounted |
|---|---|
| Maximum extraction rate | 700 m³/h |
| Lighting efficiency class | A |
| Number of speeds | 3 |
| Lighting type | LED |
| Number of bulbs | 2 |
| Bulb power | 3 W |
| Width | 70 cm |
| Colour | Stainless Steel |
To Next Page