InFocus IN2112 User Manual

7
Ceiling Mount
If you wish to install the projector on the ceiling:
• We strongly recommend using InFocus approved ceiling mounts for
proper fitting, ventilation and installation. Refer to the installation
guide that comes with the InFocus Ceiling Mount Kit (p/n SP-CEIL-
UNIV) for more information. The warranty does not cover any dam
-
age caused by use of non-approved ceiling mount kits or by installing
in an improper location.
• The ceiling must be strong enough to support the projector and the
installation must be in accordance with any local building codes. Con-
sult your dealer for more information.
• Maximum supported physical pitch is +/-8º.
• Maximum supported physical horizontal roll is +/-8º.
• Keep all adjacent surfaces 3” (76mm) from sides, front and rear and
.87” (22mm) from the bottom of projector to preserve required airflow
around the projector.
8º

InFocus IN2112 Specifications

General

Projection technology	DLP
Contrast ratio (typical)	2100:1
Projector native resolution	SVGA (800x600)
Aspect ratio	4:3, 5:4, 16:9
Power supply	288 W
RS-232 ports	1
Dimensions (WxDxH)	116.8 x 241.3 x 315 mm
Power requirements	100 - 240 V 50 - 60 Hz
Lamp power	185 W
Light source type	Lamp
Service life of light source	3000 h
Service life of light source (economic mode)	4000 h
RMS rated power	10 W
Number of built-in speakers	2
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Product type	Standard throw projector

Weight and Dimensions

Weight	3180 g