28
To replace the lamp
When replacing the lamp, use the special screwdriver that comes with the replacement
lamp. The projector does not come with a screwdriver.
1
Turn off the projector and unplug its AC power cord.
2
Wait for about 60 minutes to allow the projector’s current lamp to cool down
completely.
3
Turn over the projector and place it on top of a desk or on some other stable
surface.
4
Loosen the lamp cover screw, and then remove the lamp cover.
5
Loosen the three screws indicated by an S mark.
To Next Page
Loading...
Need help?
General
