18
VGA connection
If your video device has a 15-pin VGA output, plug one end of the included
computer cable into the VGA connector on your video source. This connec-
tor may be labeled “To Monitor” on the video source. Plug the M1 computer
end of the cable into the Computer In connector on the projector. Do not
plug the USB end of this cable into the video device.
Use the A/V cable’s red and white audio connectors as described on the
previous page (the yellow connectors on the A/V cable are not used).
M1 to Component adapter
To connect a progressive scan DVD or HD source, use an M1 to Component
adapter (available as an optional accessory). Connect one end of a compo-
nent cable (not provided) into the adapter. Connect the M1 end of the
adapter into the Computer In connector on the projector.
Connect the power cord to the Power connector on the side of the projector
and to your electrical outlet.
NOTE: Always use the power cord that shipped with the projector.
connect computer and
A/V cables
connect power cable
To Next Page
Loading...
Need help?
General
