If the backup time is still too short
after 8 hours of charge, please
contact your local distributor for
battery replacement.
Please refer to chapter 3.13.6 to
trouble shoot the problem;
otherwise, consult your local
distributor for help.
5 Bundled Software Installation Guide
5.1. Hardware Installation
1. Connect the male connector of RS232 cable to the UPS communication port.
2. Connect the female connector of the RS232 cable to a dedicated RS232 port
of the computer.
3. For optional interface cards, you may refer to Chapter 6 for installation.
5.2. Software Installation
Please refer to the userās manual of the software for installation.