2-5EonStor DS 3000 Series Hardware Manual
Assembling the slide rail kit
To assemble the slide rail kit:
1. Determine the position where the system will be installed to the front and rear rack posts, then
insert the cage nuts into the designated holes on the front rack posts.
9.0 mm M5
Rear rack postFront rack post
Unit boundary
Unit boundary
3U/4U, M5 cage nut position
2U, M5 cage nut position
2. Loosen the four screws on the slide rails then adjust its length. After the length adjustment, secure
the slide rails to the front and rear posts with the truss head screws.
Inner glide rail
9.0 mm M5
9.0 mm M5
3. Attach the inner glides to both sides of the enclosure using the athead screws no. 6-32.
No. 6-32
To Next Page
Loading...
