Installation, Operation and Maintenance Manual for Ingenia Outdoor Units CAH-OD-16-00
2
Table of Contents
1.0 Receipt and Inspection 3
2.0 Unit Identification 3
3.0 Unit Supporting Structure 3
4.0 Duct Connection 7
5.0 Caution 7
6.0 Rigging 8
7.0 Hardware and Tools needed for Installation 9
8.0 Installation Procedure for Modular Outdoor Units 10
8.1 Condensate Traps 18
8.1.1 Draw-thru Traps 18
8.1.2 Blow-thru Traps 18
8.2 Coil Removable Access Panel 18
8.3 Ingenia Panels 18
8.4 Door Hinge Adjustment 22
8.5 Filter Clips 23
8.6 Electrical Field Connections 24
8.7 Monorail Operation 26
8.8 Exhaust and Outside Air Hoods 28
9.0 Start-up (
checklists pg 34) 28
10.0 Service and Maintenance 38
10.1 Bearing Lubrication 38
10.2 Unit Cleaning 38
10.2.1 Coil Cleaning 38
10.3 Sheaves and Belts 39
10.4 Winter Shut-down to prevent Water Coils from Freezing 39
10.5 Antimicrobial Coating Protection 39
11.0 Warranty 40
11.1 Addition / Modification of components to ETL units in the field (ETL Disclaimer) 40
12.0 Replacement Parts 41
Appendix A Stacked modules and Floor Opening 42
Appendix B Pulling together wide modules on roof curb or structural steel 44
Appendix C Fan IOM 46
To Next Page
Loading...