10
For best product performance,only use heat sensitized paper approved by Ingenico.
4.3.2 Installing paper roll
¾ Open the paper cover by lifting the catch located at the top of AXIUM DX4000 and
pull the cover to the rear of the terminal.
¾ Insert the paper roll in the compartment following the directions shown on the
below picture.
¾ Pull the paper up to the top of terminal, maintain the paper and close the cover
¾ Press simultaneously on both upper corners of the paper flap until it clips into
position.
¾ Please note that the paper should be cut off upward.
ADVICE
If you insert a new R40 paper roll, tear off the first length (one complete turn to avoid
printing on adhesive footprint).
WARNING
Switch off the terminal prior to installing a paper roll. Use only paper approved by
Ingenico.
The use of no-approved paper is likely to damage the printer of your terminal.
4.4 Battery
4.4.1 Charging the battery
¾ When does the battery need to be charged?
z When used daily, the terminal charges its battery each time the power adapter is
connected. Charging starts automatically.
¾ How can the battery be charged?
Using the power adapter
z Connect the power adapter to the terminal USB type-C connector located on the left
side of the terminal.
To Next Page
Loading...
Need help?
General
