7
The terminal must never be put in or left at a location where it could be
stolen or replaced by another device.
You are strongly advises to perform regular checks on the chip card
reader.
2_3 Integration (see installation guide*)
See installation guide *.
2_4 EC standard compliance marking
EC standard compliance marking certies that the product stipulated
below: iUC150B
conforms to the following harmonized standards :
EC/EN 60950-1: Electrical safety of data processing
equipment including electrical ofce equipment.
Issue 2005 (2nd Edition) +/A1:2009 +/A2:2013
EN 55022: Data processing equipment –
Radiofrequency disturbance characteristics - Limits
and measurement methods. EN 55022 2006 + A1
(2007)
EN 55024: Data processing equipment – Immunity
characteristics - Limits and measurement methods.
Issue 1998 + A1- 2001 + A2 – 2003
2_5 IC statements
This class (B) digital apparatus complies with Canadian ICES-003.
Under Industry Canada regulations, this radio transmitter may only
operate using an antenna of a type and maximum (or lesser) gain
approved for the transmitter by Industry Canada. To reduce potential
radio interference to other users, the antenna type and its gain should
be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is
not more than that necessary for successful
communication.»
Conformément à la réglementation d’Industrie Canada, le présent
émetteur radio peut fonctionner avec une antenne d’un type et d’un
gain maximal (ou inférieur) approuvé pour l’émetteur par Industrie
Canada. Dans le but de réduire les risques de brouillage radioélectrique
To Next Page
Loading...
