Integration guide iUC150B & iUC160B
900021059 R11 000 04/0416
Copyright© 2015 Ingenico
All rights reserved
35
Product requires four M4 screws.
Length of screw is depending of panel thickness. See picture below.
Torque is 0.6-0.75 N.m
equipment front face
M4 screw (x4)
Length of screw=5mm (+0/-1mm) + thickness of the equipment front face
(thread depth of the product insert=5.9mm)
CAUTION
It is important that the device footprint surface on the kiosk must be at and cleared
of any holes and burrs to prevent from dust and water penetration in the kiosk. (IP65
standard). Rubber joint at the rear of the product guarantees waterproofness between
kiosk panel and product.
3D step les are also available upon request.
Picture product installation
To Next Page
Loading...
