Integration guide iUC150B & iUC160B
900021059 R11 000 04/0416
Copyright© 2015 Ingenico
All rights reserved
37
CAUTION
It is important that the device footprint surface on the kiosk must be at and cleared
of any holes and burrs to prevent from dust and water penetration in the kiosk. (IP65
standard)
Rubber at the rear of the product guarantees waterproofness between EVA plate and
product.
Waterproofness between EVA plate and kiosk panel should be guarantee by installer.
3D step les are also available upon request.
6_2_1 Installing the iUC150B product
EVA EPS standard mounting plate (front side)
Surface must be at and without burrs
No sharp edge
To Next Page
Loading...
