Ingenico iWL252 - Settlement Cutover

SKYZER TECHNOLOGIES PAGE 117 OF 132
INGENICO IWL25X 2017 PAYMARK SOFTWARE OPERATING GUIDE Version 1.00
12.13.5 Settlement Cutover
This function allows the merchant to settle the current settlement period and to
cut over to a new settlement period. This can only be performed successfully
when the terminal is within the ‘settlement window’ defined by Paymark for the
particular merchant and terminal.
Step
Terminal Display
Description
1.0
PAYMARK EFTPOS
1.EFTPOS MENU
2.HOSPITALITY MENU
3.ADMIN MENU
4.SUPERVISOR MENU
Press MENU key and then scroll through using down arrow key until ADMIN MENU
is shown on the display.
Press the corresponding number key or ENTER to access ADMIN menu.
2.0
ADMIN MENU
1.TOTAL
2.INQUIRY
3.CUTOCER
Press the corresponding number key or down arrow key to select CUT to perform a
settlement cutover.
3.0
1 Merchant 1
2 Merchant 2
3 Merchant 3
Only applicable with Multi-Merchant setup.
Select the corresponding number on the terminal to select the Merchant followed by
ENTER.
4.0
CUTOVER NOW?
ENTER=YES, CLR=NO
Press ENTER to initiate a settlement cutover or CLEAR to cancel and return to the
previous state.
NOTE: Terminal will prompt for any stored Tip Transactions and/or Electronic Offline
Voucher to be transmitted. Press ENTER to transmit or press CLEAR to proceed with
settlement cutover.
5.0
PROCESSING NOW
PROCESSING NOW will be displayed on the terminal while processing the
transaction.
6.0
TRANS. COMPLETE
Settlement cutover record is printed.
NOTE: Any expired stored Hospitality, EOV offline and/or Contactless
transactions, will be prompted to upload when Settlement Cutover is
performed. To upload these stored transactions at that time, press ENTER or
CLEAR to cancel upload and proceed with Settlement Cutover.