Ingenico iWL252 - Remote Key Injection (PKMS)

SKYZER TECHNOLOGIES PAGE 42 OF 132
INGENICO IWL25X 2017 PAYMARK SOFTWARE OPERATING GUIDE Version 1.00
5.7 REMOTE KEY INJECTION (PKMS)
The Ingenico iWL250 terminal supports Remote Key Injection technology to
enable automated injection of security keys from Paymark.
5.7.1 Remote Key Injection (PKMS) Configuration
This function is used to configure the Remote Key Injection operation and can
be performed through GPRS mode.
5.7.1.1 GPRS RKI Configuration
Step
Terminal Display
Description
1.0
Press FUNC
2.0
FUNCTION?
Enter 7418, press ENTER
3.0
MULTI MERCHANT
SETUP
Terminal is now in configuration mode. Go to following Steps to proceed or Press
CANCEL to exit, otherwise the terminal will automatically exit after 30 seconds of
inactivity
4.0
MULTI MERCHANT
SETUP
Select option 5 for RKI configuration by pressing the corresponding number key.
5.0
RKI CONFIG?
ENTER OR CLEAR
Press ENTER to proceed with the RKI configuration or CLEAR to cancel and exit to
idle screen
6.0
NII?
018
This parameter specifies the Network International Identifier that the terminal uses
to route messages to Paymark.
Press ENTER.
7.0
RKI
HOST IP ADDRESS
117.120.35.3
This parameter specifies the RKI HOST IP ADDRESS of the Paymark, where it will
be connecting to download the keys. By default, the RKI (PKMS) Host IP Address is
set as 117.120.35.3.
8.0
RKI
HOST PORT
7540
This parameter specifies the RKI HOST PORT of the Paymark, where it will be
connecting to download the keys. By default, the RKI (PKMS) Host Port is set as
7540.
9.0
MULTI MERCHANT
SETUP
Terminal is now in configuration mode. Press CANCEL to exit, otherwise the
terminal will automatically exit after 30 seconds of inactivity