END OF DAY REPORTS
To access the reports menu press , until ‘SYSTEM MENU’ is
displayed and then select “Totals”.
Press or to highlight the required option and press to
select it.
If required enter the supervisor password and press .
END OF DAY: This indicates the total value of transactions that have
been processed and shows that the totals have been confirmed by
the acquirer. This MUST be done at the end of each day that you
trade.
X REPORT: Shows the breakdown of transactions in different ways
enabling you to check off against individual receipts and the
“BANKING” report.
Z REPORT: Exactly the same as the “X REPORT”, except that
the Z “REPORT” resets the totals ready for the next day’s trade.
CHANGING THE PAPER ROLL
Hold the terminal securely in one hand. With the other hand, and by using two fingers, lift the
printer cover release as shown in and above. Fully open the printer cover and remove the old roll
of paper.
Unstick the end of the new roll, leaving the end free, hold the paper roll and carefully place into
the printer compartment as shown in above with the paper feeding up from the bottom.
Holding the free end of the paper and the terminal, close the printer cover and push firmly until it
locks. While your terminal is displaying the idle screen, press and hold to ensure that the paper
feeds correctly.
ONLY OPEN THE PRINTER COVER AS SHOWN - DO NOT FORCE THE PRINTER COVER
For further information on terminal functionality please download your Terminal User Guide from
https://ingenico.co.uk/smart-terminals/user-guides
or call the terminal helpdesk.
DIV434787A
COPYRIGHT © 2017 Ingenico UK Ltd
ALL RIGHTS RESERVED
To Previous Page
Loading...
Need help?
General
