4. Keep pressing ENTER until you are back at the Paymark screen
and reboot
Adding a surcharge
1. Press FUNC followed by 8 and then press ENTER
2. Press ENTER to Enable Surcharging
3. Press ENTER if you want to Enable Contactless/PayWave
Surcharging or CANCEL if you do not
4. Enter the surcharge percentage i.e., for 2.5%, enter in 2.50 then
press ENTER
5. Enter in the surcharge minimum amount i.e., if you don’t want
anything under $10 to incur a surcharge, change this figure to
$10.00, then press ENTER
6. Once you are back at the Paymark screen, reboot the terminal
Card Not Present Transaction
1. Press F1 and type in the purchase amount then press ENTER
2. At the Present Card screen, press FUNC and begin typing in the
card number then press ENTER
3. Type in the Expiry Date then press ENTER
4. Select Yes or No to answer CSC number if available
5. Type in the CSC Number and press ENTER
6. Select option 1 if this is a single transaction or option 2 if this is
a recurring payment
Enabling/Disabling PayWave/Contactless Transactions
1. Press FUNC 7418 and then ENTER
2. When you see “Multi Merchant Setup” press key 7
3. This will then read “Activate CTL?” press ENTER to activate.
4. If you are de-activating, this will read “Deactivate CTL?” press
enter to deactivate.
5. This will then read “Contactless Activated/Deactivated”, then
press ENTER
To Next Page
Loading...
