33
HYDRAULIC OIL COOLER
The hydraulic oil cooler must be kept clean and
unobstructed at all times.
Check the hydraulic oil cooler DAILY before operating
your tractor and frequently during use.
If debris builds up on the screen during tractor
operation, STOP the tractor engine immediately and
clean the debris off.
An obstructed hydraulic oil cooler can cause the
tractor hydraulic system and engine to overheat and
fail prematurely.
HYDRAULIC OIL FILTER
The hydraulic oil system is protected by an oil filter.
The hydraulic oil filter is located behind R.H. air screen
on tower.
Replace oil filter after every 500 hours of use, when
you change hydraulic oil. Replace more often if oil
becomes contaminated.
To replace hydraulic oil filter:
1. Remove R.H. air screen on tower.
2. Use suitable size filter wrench to loosen filter.
3. Apply clean oil to gasket of new filter.
4. Install filter manually until tight.
5. Tighten filter one full turn with wrench.
6. Check filter for leaks after you fill the hydraulic
system. (See Hydraulic Oil Section.)
7. Install R.H. air screen.
HYDRAULIC
OIL COOLER
FIGURE 23
FIGURE 24
R.H. AIR
SCREEN
casecoltingersoll.com
To Next Page
Loading...