InHand VG814 - Traffic Control

1. Add a network link classifier. Click "QoS >> Traffic Control >> Classifier",
check "Any Packets", set the source and destination addresses of the link, select
transmit protocols for QoS control, and click Add.
2. Set transmission policies. Click "QoS >> Traffic Control >> Policy", enter a
custom policy name for "Name", enter the classifier name for "Classifier", set the
guaranteed bandwidth, maximum bandwidth, and policy priority, and click Add.
3. Click "QoS >> Traffic Control >> Apply QoS", select the gateway interface,
enter the policy name for "Ingress Policy" and "Egress Policy", click Add, and
then click Apply & Save.
5.4.7 Traffic Control
Method for enabling traffic control for the gateway:
Click "Services >> Traffic Control", enable traffic control, set traffic control
parameters, and click Apply & Save. After the settings are completed, the system