3. After the configuration is completed, check whether PC 1 can communicate with
PC 2. If yes, the dynamic route is added successfully. The RIP route learned by
VG814_B is shown in the figure below.
5.6.2.2 OSPF
The Open Shortest Path First (OSPF) protocol is a link-status-based internal
gateway protocol mainly used on large-scale networks.
Method for enabling dynamic routing between VG814_A and VG814_B over OSPF in the
scenario:
1. Configure VG814_A. Click "Routing >> Dynamic Routing >> OSPF", check "Enable",
enter a valid IP address for "Router ID", and configure VG814_A in the "Network"
bar to announce the routing entry of VG814_A.
To Next Page
Loading...