initium Promi SD101 - AT Command Vs. Operational Status

Promi SD™ User Manual ver 1.7
www.initium.co.kr
26
6. Turn both SD units power off. The SD pair will connect automatically when
they are powered up again.
7. To release this paring, set them to MODE 0 by entering ‘AT+BTMODE, 0’. or
reset the units by pressing the RESET button.
2.2.6 AT command vs. Operational Status
The AT command sets listed above can be executed per Promi SD™
operational status. The following table shows the operational status and
executable AT command sets.
AT Command Standby Pending Online
AT<cr>
√ √
ATZ<cr>
√ √
AT+BTINQ?<cr>
√
1)
ATD112233445566<cr>
√
1)
ATD<cr>
√
1)
AT+BTSCAN,n<cr>
√
1)
AT+BTSCAN,112233445566<cr>
√
1)
AT+BTCANCEL<cr>
√
+++
√
ATO<cr>
√
2)
ATH<cr>
√
2)
AT+BTAUTH,Auth,Encr<cr>
√
3)
AT+BTMODE,n<cr>
√
3) 4)
AT+BTNAME=”Name”<cr>
√
3)
AT+BTKEY=”nnnn”<cr>
√
3)
ATS10=0 or ATS10=1
AT+BTMODE,0
OK