INK+IVY LANCASTER User Manual

Page 1 of 3
Description
QTY
Parts List
Item
P1
P2
P3
Hardware List
QTY
Description
Item
H1
H2
H3
H4
ASSEMBLY INSTRUCTIONS
Description: LANCASTER ROUND TABLE
Step1:
Assemble the table on a flat, soft surface such as a carpet or cloth to prevent scratching the finish.
Assembly Procedures:
Pre-assembly:
Take out all parts and hardware from box.
Do not discard any content until assembly is complete to avoid accidentally discarding small parts or hardware.
Important safety instructions:
Please read carefully all instructions before assembly.
For your safety and ease, assembly by two or more adults is recommended.
Keep instructions for future use.
DISCLAIMER:
WHEN PROPERLY ASSEMBLED, THIS ITEM IS SAFE FOR INTENDED USE. SELLER IS NOT LIABLE FOR ANY DAMAGES
RESULTING FROM ITEM BEING IMPROPERLY ASSEMBLED AFTER PURCHASE.
Lock Washers Ø5/16"
Flat Washers Ø5/16"x19mm
Allen Key 4mm
Mounting Board
Half Top Frame
2
1
12
24
(H2)x12
(H4)x12
(H5)x12
(H7)x1
Bolts Ø5/16"x35mm
Lock Washers Ø5/16"
Flat Washers Ø5/16"x19mm
Lock all spring clips under the table top. Then attach the Mounting Board (P2) to Half Top Frame (P1) as shown
below.
P4
H5
H6
4
2
Bolts Ø5/16"x75mm
Bolts Ø5/16"x25mm
24
H7
1
8
1
2
Bolts Ø5/16"x35mm
Metal Bracket
P5
4
Leg Frame
Half Leg Frame
LOCK
Allen Key 4mm
H5
H4
H2
H7
P1
P2
P1
P1
Gathering Height
Connector

INK+IVY LANCASTER Specifications

General

Brand	INK+IVY
Model	LANCASTER
Category	Indoor Furnishing
Language	English

Summary

Safety Instructions

Pre-Assembly Preparation

Assembly Procedures

Step 1: Mount Board to Top Frame

Attach Mounting Board (P2) to Half Top Frame (P1) using specified hardware and Allen key.

Step 2: Attach Leg Frames and Metal Bracket

Connect Half Leg Frames (P4) to Leg Frame (P3) and attach Metal Bracket (H6) using bolts and washers.

Step 3: Attach Leg Frame to Table Top

Connect the assembled leg frame to the table top using bolts, lock washers, and flat washers.

Step 4: Attach Gathering Connector

Attach the Gathering Connector (P5) and leg frame to the table top for gathering table assembly.

Step 5: Final Upright Position

Turn the assembled round table to its upright position to complete the assembly process.