3.5 Installation
The System is designed for installation in a clinic environment. To install the System,
perform the following tasks:
▪ Check the System and all its components for damage.
▪ Connect the Footswitch.
▪ Connect the power cord to the System inlet.
▪ Plug the System power cord into an appropriate electrical outlet.
3.6 Moving the System:
▪ Turn the System off.
▪ Disconnect the Power Cord.
▪ Disconnect the Footswitch.
▪ Release the wheel brakes.
▪ Slowly push or pull the System using the handle.
▪ When moving to another facility, lift the System to the vehicle and lay it carefully on
its side.
Never lift, pull or push the System using the operating panel.
Always use the handles when moving the System.
Upon unpacking check the System for mechanical damage (e.g., cracks in the
cable insulation).
Never lift, pull or push the System using the operating panel.
Always use the handles when moving the System.
Upon unpacking check the System for mechanical damage (e.g., cracks in the
cable insulation).
To Next Page
Loading...
