Section 5: System Operation
This section of the manual explains how to start the device, operate it and turn it off.
Prior to using or connecting the Handpiece, inspect the System and Handpiece
for possible mechanical damage.
5.1 Device Start-Up
1. Connect the Handpiece to the Handpiece connector socket on the front panel.
2. Turn on Main Power switch at the rear panel.
3. Press the On-Off button on the control panel to turn the device on. The System
loads the software and enters the Login Screen.
4. Enter password to get access to the treatment screen.
5. The system loads the software and enters a self-test mode. If any problem is
detected during the test, an error message will appear (See Troubleshooting
Section in this manual). If the test is passed correctly then the system
automatically enters the Treatment Screen.
6. Select treatment parameters using touch screen.
7. Enter Ready mode to confirm the selected parameters. The System is ready for RF
delivery.
8. Press footswitch to start procedure.
5.2 System Shutdown
To shut down the System turn the On-Off switch on the front panel off. Turn the Main
Power switch off at the end of the day.
To Next Page
Loading...
