Need help?Do you have a question about the Innovative Technology NV10 Family and is the answer not in the manual?
Lists documents relevant to the NV10 USB/+ manual for integration and programming.
Details revisions and dates of amendments made to the user manual.
States the copyright ownership and reproduction policy for the manual.
Outlines the warranty period and conditions for Innovative Technology hardware products.
Highlights key safety points and warnings to be aware of when using or maintaining the product.
Clarifies Innovative Technology's responsibility regarding product installation and use.
Provides an overview of the NV10 USB/+ as a compact, stackerless banknote validator.
Lists the main characteristics of the NV10 USB/+, such as design and reliability.
Describes common uses for the NV10 USB/+, like amusement and vending.
Identifies the main physical parts of the NV10 USB/+ validator.
Details the different bezel types available for the NV10 USB/+ validator.
Specifies physical dimensions, weight, and environmental operating requirements.
Details power supply specifications and media size requirements for the validator.
Discusses compatibility with other products and potential issues during replacement.
Step-by-step instructions for safely removing the bezel from the validator.
Provides guidance on fitting a free-fall cashbox to the NV10 USB/+ unit.
Overview of software setup, downloads, and necessary drivers for the validator.
Details on programming the validator using datasets and firmware files.
Instructions for using the DA3 handheld system for validator reprogramming.
Explains how to use configuration cards for various interface modes.
Describes the operation and functions of the validator's configuration button.
Overview of communication protocols, focusing on SSP and eSSP for secure interfacing.
Information on the ccTalk serial communication protocol and its DES encryption.
Details on the MDB protocol and the IF5 interface for vending machine compatibility.
Explanation of the Parallel interface, including pinout and control functions.
Description of the Binary interface for denomination output on parallel pins.
Details on the outmoded SIO and SI2 serial communication protocols.
Information on the Pulse interface for note acceptance using timed pulses.
Details on the IF15 interface for using serial SSP with machines.
Explains the importance of routine maintenance for validator performance.
Recommends intervals for cleaning optical lenses and changing drive belts.
Lists and explains bezel LED flash codes indicating validator errors.
Guidance on checking connections and procedures for verifying validator settings.
Introduction to using troubleshooting aids like flash codes and flow charts.
A visual guide to diagnose and resolve common validator issues.
Detailed steps for cleaning the validator's internal components and drive belts.
Instructions for re-initialising validator sensors using diagnostic tools.
Details compliance with Harmonised European Standards and RoHS directives.
Technical drawings and specifications for various interface cables.
Procedures for switching to programming mode and enabling DES trusted mode.
Explanation of the escrow facility and its operational timing diagrams.
Diagram illustrating the timing sequence for the validator's low power mode.
Product Change Notification regarding the ST processor revision.
Explains the system for naming dataset and firmware files.
General| Brand | Innovative Technology |
|---|---|
| Model | NV10 Family |
| Category | Bank Note Validator |
| Language | English |
To Next Page