Description of Function Codes
MD280 User Manual
- 138 -
,IUHODWLYHWRWKHFHQWUDOIUHTXHQF\) $:VZLQJDPSOLWXGH )[)
,IUHODWLYHWRWKHPD[LPXPIUHTXHQF\) $: )[)
-XPSIUHTXHQF\ $:[)
,IUHODWLYHWRWKHFHQWUDOIUHTXHQF\) WKHMXPSIUHTXHQF\LVDYDULDEOHYDOXH
,IUHODWLYHWRWKHPD[LPXPIUHTXHQF\) WKHMXPSIUHTXHQF\LVD¿[HGYDOXH
The swing frequency is limited by the frequency upper limit and frequency lower limit.
Function Code Parameter Name Setting Range Default
F7-03 Swing frequency cycle 0.0–3000.0s 10.0s
F7-04 7ULDQJXODUZDYHULVLQJWLPHFRHI¿FLHQW 0.0%–100.0% 50.0%
)VSHFL¿HVWKHWLPHRIDFRPSOHWHVZLQJIUHTXHQF\F\FOH
)VSHFL¿HVWKHWLPHSHUFHQWDJHRIWULDQJXODUZDYHULVLQJWLPHWR)6ZLQJIUHTXHQF\
F\FOH
7ULDQJXODUZDYHULVLQJWLPH )[)XQLWV
7ULDQJXODUZDYHIDOOLQJWLPH )[±)XQLWV
When the AC drive runs at the swing frequency, if the central frequency changes, the
AC drive stops swing, and starts swing again only after running from the current central
IUHTXHQF\WRWKHPRGL¿HGYDOXH
Function Code Parameter Name Setting Range Default
F7-05 Set length 0–65535 m 1000 m
F7-06 Actual length 0–65535 m 0 m
F7-07 Number of pulses per meter 0.1–6553.5 100.0
7KHSUHFHGLQJSDUDPHWHUVDUHXVHGIRU¿[HGOHQJWKFRQWURO
The length information is collected by means of the pulse signal of a DI terminal allocated
ZLWKIXQFWLRQ/HQJWKUHDFKHG:KHQWKHSXOVHIUHTXHQF\LVKLJK',PXVWEHXVHG
)$FWXDOOHQJWKUHFRUGVWKHFRXQWOHQJWK6HWWKLVSDUDPHWHUEHIRUHOHQJWKFRXQWLQJDV
the initial value.
$FWXDOOHQJWK ,QLWLDOOHQJWKYDOXH1XPEHURISXOVHV)
:KHQWKHDFWXDOOHQJWK)H[FHHGVWKH VHWOHQJWKLQ)WKH'2WHUPLQDODOORFDWHG
ZLWKIXQFWLRQ/HQJWKUHDFKHGEHFRPHV21
The actual length can be viewed in real time. For details, see the descriptions of F7-13 and
F7-14.
Function Code Parameter Name Setting Range Default
F7-08 Set count value 1–65535 1000
F7-09 Designated count value 1–65535 1000
efesotomasyon.com
To Next Page
Loading...
