Inovance MD380 Series

MD380 User Manual Desc
ription of Function Codes
- 223 -
*URXS)38VHU3DVVZRUG
Function Code Parameter Name Setting Range Default
FP-00 8VHUSDVVZRUG 0–65535 0
If it is set to any non-zero number, the password protection function is enabled. After a
password has been set and taken effect, you must enter the correct password in order to
enter the menu. If the entered password is incorrect you cannot view or modify parameters.
If FP-00 is set to 00000, the previously set user password is cleared, and the password
protection function is disabled.
Function Code Parameter Name Setting Range Default
FP-01
Parameter
initialization
0: No operation
1: Restore factory parameters except motor
parameters
2: Clear records
4: Back up current user parameters
501: Restore user backup parameters
0
 1: Restore factory parameters except motor parameters
If FP-01 is set to 1, most function codes are restored to the factory parameters except
motor parameters, frequency reference resolution (F0-22), fault records, accumulative
running time (F7-09), accumulative power-on time (F7-13) and accumulative power
consumption (F7-14).
 2: Clear records
If FP-01 is set to 2, the fault records, accumulative running time (F7-09), accumulative
power-on time (F7-13) and accumulative power consumption (F7-14) are cleared.
 4: Back up current user parameters
If FP-01 is set to 501, the current parameter settings are backed up, helping you to
restore the setting if incorrect parameter setting is performed.
 501: Restore user backup parameters
If FP-01 is set to 4, the previous backup user parameters are restored.
Function Code Parameter Name Setting Range Default
FP-02
AC drive
parameter display
property
0: Not display
1: Display
11
8QLWVGLJLW*URXS8
Ten's digit: Group A
FP-03
Individualized
parameter display
property
0: Not display
1: Display
00
8QLWVGLJLW8VHUGH¿QHGJURXS
7HQVGLJLW8VHUPRGL¿HGJURXS
efesotomasyon.com