Inovance MD880-01S-0751-4 - Page 149

Appendix: Installation of the Sheet Metal Base and Side Entry Output Copper Busbar
- 148 -
Step Demonstration
Step 3: Remove the left, right,
and front ba󶎁e plates (shown
by 1, 2, and 3 respectively in the
right 󶍾gure) of the sheet metal
base.
Ю
Я
а
Step 4: Install the sheet metal
base to the bottom of the AC
drive by securing the screws.
◆
T10 and T11: Six M8 x 20
hexagon head SEMS screws
◆
T12: Four M8 x 20 hexagon
head SEMS screws (1, 2, 5,
and 6 shown in the right
󶍾gure); two M6 x 16 SEMS
screws (3 and 4 shown in
the right 󶍾gure)
Ю
Я
б
г
а
в
Step 5: Install the plastic ba󶎁e
plates on the sheet metal base.
Ю
Я