Introduction
-
7
-
Function Description Remarks
Service
suspension
output
When the elevator cannot respond to hall calls, the corresponding terminal
outputs the service suspension signal.
-
Running times
recording
In automatic running state, the system automatically records the running
times of the elevator.
Recorded in F9-
11/12
Running time
recording
The system automatically records the accumulative working hours and
working days of the elevator.
Recorded in F9-
09
Automatic
door open
upon door lock
abnormality
If the system detects that the door lock circuit is abnormal during door open/
close, the elevator automatically opens and closes the door again, and reports
a fault after the set door open/close times is reached.
FB-09 "Door
open/close
times"
VIP service
persons.
-
Disability service
When the elevator is waiting at the leveling position, if there is a call at
prolonged. It is the same for the back door.
FB-15 "Special
door open
holding time"
Full-load direct
running
When the car is full-loaded in automatic running state, the elevator does not
still be registered, and will be executed at next time of running (in the case of
single elevator) or by another elevator (in the case of parallel/group control).
-
Overload
protection
When the car load exceeds the rated elevator load (Overload condition: When
the car load exceeds 110% of the rated load, the elevator enters the overload
state), the elevator gives an alarm and stops running without door close.
-
Fault data
recording
The system automatically records detailed information of faults, which helps
Groups FC and
E0 to E9
Inspection-related Functions
Simple
maintenance
keypad
The 3-button keypad on the MCB provides the functions such as
-
Operation box
commissioning
The hand-held manipulator can be connected to the system in the car for
-
Shaft auto-
tuning
automatically records all position signals in the shaft in the running process.
F1-11 "Auto-
tuning mode"
parameter
display
setting.
FP-02
Inspection
running
After entering the inspection state, the system cancels automatic running
and related operations. You can press the up or down call button to make the
elevator jog at the inspection speed.
-
Emergency
motor-operated
running
After entering the emergency motor-operated running state, the system
cancels automatic running and related operations. You can press the up or
down call button to make the elevator jog at the emergency motor-operated
speed.
Refer to the
description of
parameters in
group F5
Motor auto-
tuning
With simple parameter setting, the system can obtain the motor parameters
no matter whether the motor is with-load or without load.
-
To Next Page
Loading...