Inovance Monarch NICE300new Series - Page 30

- 29 -
2 System Commissioning
2
2. F-1: command input of the running oor
After you enter the F1 menu, the 7-segment LEDs display the bottom oor (F6-01). You can press the
UP button to set the destination oor within the range of lowest to top and then press the SET button
to save the setting. The elevator runs to the destination oor, and the display switches over to the F0
menu at the same time.
3. F-2: fault reset and fault code display
After you enter the F-2 menu, the 7-segment LEDs display “0”. You can press the UP button to
change the setting to 1 or 2.
Display “1”: If you select this value and press the SET button, the system fault is reset. Then, the dis-
play automatically switches over to the F0 menu.
Display “2”: If you select this value and press the SET button, the 7-segment LEDs display the 11 fault
codes and occurrence time circularly. You can press the PRG button to exit.
4. F-3: time display
After you enter the F-3 menu, the 7-segment LEDs display the current system time circularly.
5. F-4: contract number display
After you enter the F-4 menu, the 7-segment LEDs display the user’s contract number.
6. F-5: running times display
After you enter the F-5 menu, the 7-segment LEDs display the elevator running times circularly.
7. F-6: door open/close control
After you enter the F6 menu, the 7-segment LEDs display “1-1”, and the UP and SET buttons respec-
tively stand for the door open button and door close button. You can press the PRG button to exit.
8. F-7: shaft auto-tuning command input
After you enter the F-7 menu, the 7-segment LEDs display “0”. You can select 0 or 1 here, where “1”
indicates the shaft auto-tuning command available.
After you select “1” and press the SET button, shaft auto-tuning is implemented if the conditions are
met. Meanwhile, the display switches over to the F0 menu. After shaft auto-tuning is complete, F-7 is
back to “0” automatically. If shaft auto-tuning conditions are not met, fault code “E35” is displayed.
9. F-8: test function
After you enter the F-8 menu, the 7-segment LEDs display “0”. The setting of F-8 is described as fol-
lows:
1 Hall call forbidden
2 Door open forbidden
3 Overload forbidden
4 Limit switches disabled
6 Entering slip experiment state
7 UCMP manual detection
8 Manual detection of braking force
9 Balance coefcient detection
10 Slip amount test
The procedure of balance coefcient detection is as follows:
Step 1. Set F-8 to 9. The HCB at hall displays “
⊙
”, and the keypad automatically displays the last
balance coefcient “XXP” (“P” indicates percentage). The elevator automatically runs to the bottom
oor and opens the door, and the keypad displays “0.0P” in blinking state. Put a weight inside the car,
and manually enter the load (for example, 40.0, indicating 40.0%).
Step 2. Hold down SET; the keypad displays the oor number, and the system starts to detect the bal-
ance coefcient. The elevator automatically runs to the top oor and then back to the bottom oor; “OP”