13
Battery replacement
Battery replacement
2.
Sort out the electric wire and stuff it besides the battery and then lock the
battery cover.
Switch on and check if the machine works normally.
1. Turn off the power switch at the bottom of the product. (figure 1)
3.
4.
5.
6.
7.
8.
! Note:
Ban:
Do not use rechargeable batteries.
Battery cover
The power
switch
Figure 1.
Figure 2.
Screws of the battery cover
Figure 3.
Figure 4. Figure 5.
The battery conductor color corresponds to the color of the machine
interface wire , and the installation plug has auti-installation fuction.(fig-
ure 5)
Use a screwdriver to remove screws of the battery cover at the bottom
of the machine. (figure 2)
After the battery cover is removed, take out the battery.
Slightly open the lock of the battery connecting plug to separate the
battery from the host. (figure 3, figure 4 )
Put the new battery into the battery case and keep the face with charac-
ters upwards.
The original manufacturer's battery must be used for replacement, other-
wise the main engine may be damaged or accidental. Please refer to the
"product parameters" for the battery specification.
After the battery is replaced, the new one shall be charged above 6h for
the first time.
Please recycle the old battery for environmental protection after it is
replaced.
A.
B.
C.
To Next Page
Loading...
