31
Insignia 24" LED TV
www.insigniaproducts.com
Using analog audio
When you connect a home theater system or sound bar to the /AUDIO OUT jack, the TV speakers are muted.
To connect a home theater system or sound bar using analog audio:
1 Make sure that your TV’s AC power adapter is unplugged and the home theater system or sound bar is turned
off.
2 Connect a 3.5mm audio cable (not provided) to the /AUDIO OUT jack on the side of your TV and to the
AUDIO IN jacks on the analog home theater system or sound bar.
3 Plug your TV’s AC power adapter into a power outlet, then turn on your TV.
4 Turn on the home theater system or sound bar, then set it to the correct source mode. For more information, see
the documentation that came with the home theater system or sound bar.
Notes
• For information about selecting the audio out mode for a home theater
or sound bar, see the Headphone/Audio Out option in “Adjusting
sound settings” on page 43.
• If you want to use headphones, you need to disconnect the amplifier,
home theater system, or sound bar.
3.5mm audio
cable
Home theater system
Side of TV
3.5mm audio
cable connector
/AUDIO OUT
jack
On your TV
To Next Page
Loading...
Need help?
General